This isn't probably the best place to post this, but I have confidence that the members of LET can help me. :3
I'm currently facing an issue with my servers where it is only bursting to 100mbits, instead of the 1GBit/s that it should. This is happening on all of my servers that use the X9SCL-F-O. I can confirm that the issue is not switch or cable related (my custom-built dells are bursting just fine). I am stuck on what to do, here's my output of ethtool (I am running CentOS 6.3 min):
[root@MMCS ~]# ethtool eth1
Settings for eth1:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 2
Transceiver: internal
Auto-negotiation: on
MDI-X: on
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000007 (7)
Link detected: yes
(eth0 is off because it is connected to a failover switch, which isn't ready for use yet)
Any ideas?